Exterior of Lourenties Church

Lourenties Church: three walls monitored after installation

18/11/2026
White ATG installed on a shelf in a corner, customer photograph

A shelf and an ATG: a discreet customer installation

18/11/2026
Exterior of Lourenties Church

Lourenties Church: three walls monitored after installation

18/11/2026
White ATG installed on a shelf in a corner, customer photograph

A shelf and an ATG: a discreet customer installation

18/11/2026
Show all

An ATE installed by the customer in Saint-Denis: neat and simple

ATE installed by a customer in Saint-Denis, with its cable in trunking

A wall-mounted unit, a cable routed through trunking and a nearby power supply: this customer photo from Saint-Denis, Réunion, shows an ATE installation inside a home. The device sits above the skirting board without taking up floor space. The photograph was supplied to Humidistop as an example of installation by the customer; their name and address are withheld.

A guide to the names used in our references: STOP ONE corresponds to the ATE family of mains-powered electromagnetic polarity inverters. GEOSTOP corresponds to the ATG family of geomagnetic polarity inverters without an electrical connection. Specifications and installation instructions remain specific to each model.

Three details make the installation easy to understand

The housing hangs from its fixing points. Its cord runs down from the unit and follows a protected route. A red indicator is visible in this photograph. These details illustrate the practical sequence: prepare the position, secure the device and connect the power supply specified for that reference.

Choose the position before drilling

Installation without a line of chemical injections still requires suitable wall fixings. Choose the exact model and coverage for the building, mark the affected walls on a plan and follow the instructions supplied with the device. Check the wall type, installation height and clearances from other equipment. For the ATE LC range, the documentation specifies a damp load-bearing wall and continuous mains power. A customer photo does not independently verify every clearance.

Quick installation and gradual wall drying are different stages

No timed record was supplied for this installation, so no precise installation duration is claimed. The photo documents the installed unit and wiring; it is neither a moisture measurement nor a before-and-after comparison. Identify the cause of the damp and deal separately with leaks, water ingress and condensation. Prepare finishing work according to the actual condition of the substrate and any salts.

Planning a similar installation?

Gather a floor plan and dated photographs of the affected walls. Humidistop France can help you check the device reference, coverage and installation conditions. Keep the installation instructions with the equipment and follow the drying process over time.

Source

Customer photograph supplied to Humidistop, installation in Saint-Denis. Technical guidance: the ATE LC installation instructions supplied by Humidistop France.

Humidistop France

Choose your Humidistop device

Is your problem caused by rising damp? Discover the ATE and ATG ranges made in France, with a 10-year manufacturer’s warranty under the terms of the product pages. Compare models, coverage and direct factory prices to choose the reference suited to your home.

View models and prices

Compare ATE and ATG · Need advice before ordering?