Anonymised home 13: photograph from the wall moisture inspection

Home 13: geomagnetic monitoring and changing sample conditions

18/11/2026
Anonymised home 10: photograph from the installation report

Home 10: an installation record and measurement photographs

18/11/2026
Anonymised home 13: photograph from the wall moisture inspection

Home 13: geomagnetic monitoring and changing sample conditions

18/11/2026
Anonymised home 10: photograph from the installation report

Home 10: an installation record and measurement photographs

18/11/2026

This Humidistop France case file brings together the observations available for one building. It is intended to help property owners prepare a project from dated records, the construction materials and the conditions of each sample.

Private-home reference; the owner’s name and address are withheld.

Installation took place on 11 December 2014; the follow-up table is dated 23 October 2017.

Measurements recorded in the report

Measurements recorded in the report
Sampling point Initial record Follow-up record
Garden-side external wall 3.7 gr 1.25 gr
Road-side external wall 3.2 gr Not sampled at follow-up

The model recorded is STOP ONE 30. Samples are described as 20 g, taken 30 cm above the floor and 20 cm deep. The second point was not sampled again; no final reading is invented.

How to interpret the follow-up

The report describes drying still in progress and recommends separate work on road-side water penetration, external waterproofing and rainwater disposal.

Preparing the next steps for your building

Before selecting equipment, locate the affected walls on a plan and separate rising damp from rainwater entry, plumbing leaks and condensation. Keep dated photographs and note any changes to gutters, drainage, ventilation or wall finishes. These details matter when discussing coverage and placement.

What can this reference establish?

The figures describe the sampled points and the visits stated in the document. They do not establish a uniform condition throughout a building. Where locations or sample conditions changed, keep that limitation alongside the result. Finishing work should follow the actual condition of the substrate and any salts remaining in it.

How should equipment be compared?

Compare the exact technical reference, its coverage diameter, installation instructions and power requirements. ATE equipment is electromagnetic and uses electricity; ATG equipment is geomagnetic and operates without a mains connection. Keep the historical model in the report distinct from a model currently on sale. Address other water sources as part of the project.

Other Humidistop France references

Source: Humidistop site report supplied for this reference. Conclusions are attributed to that document; readings retain their original units and sampling limits.

Choose your Humidistop device

Is your problem caused by rising damp? Discover the ATE and ATG ranges made in France, with a 10-year manufacturer’s warranty under the terms of the product pages. Compare models, coverage and direct factory prices to choose the reference suited to your home.

View models and prices

Compare ATE and ATG · Need advice before ordering?