An ATG in a school: installation on a small shelf

An ATG in a school: installation on a small shelf

18/11/2026
An ATG inside wooden storage: a close-up customer photo

An ATG inside wooden storage: a close-up customer photo

18/11/2026
An ATG in a school: installation on a small shelf

An ATG in a school: installation on a small shelf

18/11/2026
An ATG inside wooden storage: a close-up customer photo

An ATG inside wooden storage: a close-up customer photo

18/11/2026

This customer view shows a cylindrical ATG on a board supported by two brackets in the corner of a room with mouldings. A ladder is visible below. The photo illustrates the support arrangement; the location and exact model were not supplied.

GEOSTOP refers to the ATG family of geomagnetic polarity inverters without an electrical connection. STOP ONE refers to the mains-powered ATE family of electromagnetic polarity inverters. This photograph shows an ATG.

Prepare the support and position

The example shows a discreet installation on a wall-mounted support. Check the support’s stability, load capacity and wall material. Position, coverage and clearances must follow the instructions for the exact model. The height in this photograph is not a universal installation instruction.

An installation photo and a follow-up plan

The photograph documents an installed device. No moisture readings, timed installation record or before-and-after result accompany it. Keep dated photographs and comparable readings to follow the walls over time. Leaks, water ingress and condensation require their own interventions. Restore finishes according to the actual condition of the substrate.

Choose your Humidistop device

Is your problem caused by rising damp? Discover the ATE and ATG ranges made in France, with a 10-year manufacturer’s warranty under the terms of the product pages. Compare models, coverage and direct factory prices to choose the reference suited to your home.

View models and prices

Compare ATE and ATG · Need advice before ordering?